Door stop with dual installation. Door stop designed and manufactured by Herrajes Evi to protect walls, radiators or any other element in the room from possible knocks caused by doors.
Choose the installation method you want. Use the 3M adhesive pad on smooth floors. If the floor is rough or the doors are heavy, e.g. armoured, install the stopper by screwing the threaded base to the floor. Install it and don’t worry about it.
Manufactured with solid bars, to obtain high quality doorstops. This is a functional, elegant and robust stopper. Available in various finishes to match the door fittings or the decoration of the home.
Available finishes:
- Satin matt stainless steel and black natural silicone rubber
- Satin matt stainless steel and white natural silicone rubber
- White lacquered stainless steel and white natural silicone rubber
- Black lacquered stainless steel and black natural silicone rubber
- Satin matt brass and black natural silicone rubber
- Satin matt brass and white natural silicone rubber
- Antique leather finish brass and black silicone rubber
The dimensions of the adhesive stopper are as follows: 35 millimetres in diameter, 46 millimetres in diameter including the rubber and 22 millimetres high.
How to install the stopper:
1.Choose the place of installation*.
2.Clean the surface with a damp cloth, making sure that no residue is left.
3. Without removing the protective film of the adhesive, slightly heat the adhesive pad of the stopper with a hairdryer to increase its adhesion capacity.
4.Remove the protective film without touching the adhesive with your hands, as it may lose its adhesion properties.
5.Install the stopper in the desired location and press firmly for 1 minute.
6.After installation, wait 24 hours for the adhesive to set so that it can perform its function as a stopper correctly.
*We do not recommend the installation of the adhesive stoppers on rough floors or floors finished with special paints, in this case we recommend the stoppers with screw fixing.
**In the case of screw fixing, follow the first two steps and drill the hole and then screw on the threaded base. In this way it can be used immediately after installation.
