Rotating retainer and door stop for holding doors. Capable of holding doors up to 70 millimetres. This door retainer is ideal for entrance doors, hotel doors or local doors.
Choose the installation method of your choice. Depending on the type of floor material, for example, fix it with its 3M adhesive pad or screw it in place by screwing the threaded base of the stop to the floor.
The head of the two stops that make up the retainer have natural silicone protections to absorb shocks and avoid damaging the doors.
Two functions in one! Holds the door when the door is positioned between the two stops, sliding the plate under the door to retain it and, as a door stop, when the plate with the pivot stop is positioned towards the wall.
Designed and manufactured by Herrajes Evi, we have the following finishes available:
- Satin matt stainless steel and black silicone rubbers.
- Satin matt stainless steel and transparent rubbers.
- White lacquered stainless steel and white silicone rubbers.
- Black lacquered stainless steel and black silicone rubbers.
- Matt satin brass and black silicone rubbers.
- Matt satin brass and white silicone rubbers.
- Leather finish brass and black silicone rubbers.
The dimensions of the retainer are as follows: 19 millimetres in height (rotating stop), 33 millimetres in height (fixed stop), 70 millimetres of retention surface and 125 millimetres in total length.
IMPORTANT: a free space of at least 5 millimetres between the floor and the door is necessary for it to perform its retention function.
How to install the door retainer:
1. Choose the place of installation*.
2. Clean the surface with a damp cloth, making sure that no residue is left.
3. Without removing the protective film of the adhesive, slightly heat the adhesive pad of the stopper with a hairdryer to increase its adhesion capacity.
4. Remove the protective film without touching the adhesive with your hands, as it may lose its adhesion properties.
5. Install the retainer in the desired location and press firmly for 1 minute.
6. After installation, wait 24 hours for the adhesive to set so that it can perform its function as a stopper correctly.
*We do not recommend installing the adhesive stops on rough floors or floors finished with special paints, in this case we recommend stops with screw fixing.
**In the case of screw fixing, follow the first two steps and drill the hole and then screw on the threaded base. In this way it can be used immediately after installation.
